Bus Pirate v2 (assembled)

The BusPirate v3 is a universal bus interface that talks to electronics from a PC serial terminal, eliminating a ton of early prototyping effort when working with new or unknown chips.
Model:THM180C4M

Features

• USB interface, USB powered
• 0-5.5volt tolerant pins
• 0-6volt measurement probe
• 1Hz-40MHz frequency measurement
• 1kHz – 4MHz pulse-width modulator, frequency generator
• On-board multi-voltage pull-up resistors
• On-board 3.3volt and 5volt power supplies with software reset
• Macros for common operations
• Bus traffic sniffers (SPI, I2C)
• A bootloader for easy USB firmware updates
• Transparent USB->serial bridge mode
• 10Hz-1MHz low-speed logic analyzer
• Custom support in AVRDUDE, Flashrom
• AVR STK500 v2 programmer clone
• Scriptable from Perl, Python, etc.
• Translations (currently Spanish and Italian)

Resources and Supports

• Bus Pirate manual
• Chip demonstrations
• Latest firmware
• Bus Pirate forum

Copyright (c) 2008-2016 Seeed Development Limited (www.seeedstudio.com / www.seeed.cc)

This static html page was created from http://www.seeedstudio.com/wiki